Hofmann® Scissor Alignment Lifts are easy to operate, provide increased accessibility to alignment adjustment areas, and are easy to load. Space-saving design allows for up to five scissor lifts to fit into the same operating space as four 4-post lifts.

Locked and Lighted models provide productivity enhancements while allowing the technician to perform critical tasks while minimizing alignment process operations, by illuminating both inspection and adjustment areas, and by sequencing the locking of alignment plates.

  • True Task Lighting System (Lights and Locks Models)

    • Patented auto on/off light feature ensures no power when operating in the hazard zone
    • Patented light mounting position optimizes viewing angle, illuminating key inspection and adjustment areas
    • Approved for use in Class 1 Division 1 environments for both surface and flush mount models
  • Additional Features

    • Maintenance reduced rear slip plates use oversized, encapsulated bearings that roll upward to protect against environment debris
    • Four hydraulic cylinders in a cross aligned arrangement provide secure lifting power and added safety
    • Approach ramps are equipped with end sliders to minimize noise and reduce floor damage
    • Adjustable maximum lift height suits locations with low ceilings
    • Safety systems include:
      • Mechanical locking with pneumatic safety lock release from the control console
      • Flow sensing valves within the hydraulic control circuit
      • Redundant hydraulic safety system with cross aligned hydraulic circuits
    • On-board Filter/Regulator/Lubricator (FRL) provides clean and lubricated air to help reduce maintenance and protect pneumatic systems
    • Models equipped with locks and lights;
      • have ease locking control activation from the lift console to reduce walking and effort from resetting alignment pins in plates
      • include locking components made from corrosion resistant materials
      • illuminate alignment adjustment and calibration areas
      • front LEDs are mounted in the front turnplate base to easily accommodate varying vehicle wheel tracks
      • rear LEDs are strategically positioned on the rear slip plates
    • All models have been tested and validated by an independent third party to the ANSI/ALI automotive lift standard, ALCTV-2011
Expand ▼
File size : 391.29 Kb
Capacity 14000 lbs.
Power supply 230 VAC 1ph 50/60 Hz
Weight 6387 lbs
Width Between Runways 38 inch
4 Wheel Alignment Wheelbase 88 - 155 inch
2 Wheel Alignment Wheelbase 180 inch
Console Dimensions DxWxH 16.5 x 14.125 x 45.755 inch
Air Supply Requirements 90 - 120 Psi
Overall Length 270 inch
Service Wheelbase 194 inch
Overall Width 92.5 inch
Runway Width 26 inch
Standard bay flush mount with lights and locks EELR790A
Standard bay surface mount with lights and locks EELR789A
Short bay flush mount with lights and locks EELR786A
Short bay surface mount with lights and locks EELR785A
Short bay flush mount EELR784A
Short bay surface mount EELR783A